Dewatering process of screw squeeze juicer:

The screw squeeze juicer extrudes vegetables and other materials in the form of a screw. When the object is put into the equipment, the screw moves forward, and the material is continuously squeezed under the pressure of the screen wall and cone to extrude the juice, which flows into the corresponding funnel through the screen hole. The extruded vegetable residue can be discharged through the outlet. The whole process is very fast and efficient, without material blockage.

The equipment is made of stainless steel with closed structure. Therefore, during the pressing process, the materials will not rotate out of the equipment, but also can reduce the entry of microorganisms to protect people's health.

Use and maintenance of screw squeeze juicer:

1. Before use, the contact part between equipment and materials should be cleaned with detergent;

2. Do not directly stop the machine when the extrusion work is near the end and needs to be stopped. First, reduce the pressure of the hydraulic system, and push the residue of extruded and dehydrated materials open the forced door at the end of the screen bucket; Or lift the forced gate manually, and then let the machine continue to run for a period of time until the material residues in the screen bucket can not be continuously discharged from the forced gate, and then stop the machine to clean the remaining material residues in the screen bucket;

3. During the operation of the machine, try to avoid excessive pressure, otherwise the machine will stop suddenly or the screen barrel will break;

4. The oil temperature of the hydraulic system shall not exceed 600 ℃. Due to the high pressure of the hydraulic pump, it is recommended that the high pressure of the oil pump should not work continuously for more than half an hour; In the transmission system, the temperature rise of each bearing shall not exceed 40 ℃;

5. During the operation of the machine, do not let sharp and hard objects and metal objects enter the machine body. They will damage the parts in the machine body and affect the normal operation of the machine;; It can be selected before material pressing;

6. If the machine is not used for a long time, water gun must be used to wash all material residues in the machine body, and the rusty parts must be coated with grease for protection and placed in a ventilated and dry place;

7. The oil of the hydraulic system shall be kept clean. When refueling or changing the oil, the oil shall be filtered with a 120 mesh filter screen;

8. All bearings of the transmission system shall be regularly injected with lubricating grease for maintenance; The gearbox shall be regularly injected with lubricating oil for maintenance; The hydraulic oil tank shall be regularly filled with hydraulic oil for maintenance.