How to select the appropriate screw press equipment?

1. When selecting the fruit screw press, we should pay attention to understand the performance of the equipment. If there is no specific understanding of its performance and quality, many failures will occur in the use process, affecting the service life.

2. The manufacturer of the screw press recommends knowing the manufacturer when purchasing. Different manufacturers have different reputations. If you want to buy a high-quality screw press, you should improve the overall reputation of the decompression manufacturer. If everyone praises it, you can choose the manufacturer's equipment. If you feel unreliable, don't choose it.

3. In addition, it is also necessary to compare prices when purchasing screw presses. Some manufacturers have high prices, and some have low prices.

Inspection process of screw press:

As a kind of slag solid-liquid separation mechanical equipment, it is more important to check the screw press during operation. It can check whether the equipment can work properly. If there is a problem, it can be found and solved as soon as possible to reduce the probability of common faults in equipment operation.

Generally speaking, the inspection process of screw press is from switch power supply, cyclone switch to screw shaft, conveyor belt, etc. Before the on-board inverter, check whether the power circuit is firmly connected, intact and accurate, and then plug it in. Turn on the power switch of the pneumatic valve as the main control box to display the gas. Then check each pneumatic component for air leakage, blockage and other adverse conditions. Check whether the conveyor belt is suitable, open the centrifugal pump used to clean the conveyor belt, check whether there is water seepage in each pipeline and whether the water flow is normal.

When cleaning the screw press at ordinary times, the dirt on the shell should be cleaned, but the motor, switch power box and other connecting power circuits should be prevented from contacting with water. When the equipment is running, check whether the screws at each connection position are loose and whether there are cracks at the welding position with the vibration.