Application features of screw press:

1. Low operation cost

The screw press adopts the physical extruding dehydration principle. No additional heat source is required in the dehydration process, and the energy consumption is extremely low compared with similar drying equipment.

2. Large continuous working capacity

Through mechanical calculation and analysis, the special process is used to increase the axial thrust to completely solve the problem of skidding, bridge erection, material return, axle reporting and other reasons that lead to the failure of continuous work, and the handling capacity in unit time is greatly increased.

3. Low slag moisture

Because there are many kinds of materials to be dehydrated, and the data of water content, molecular water ratio, viscosity, fiber content, water absorption, toughness, organic or inorganic substances of different materials are different, our engineers will analyze the dehydrated materials provided by each customer, calculate the material parameters, make appropriate equipment, and use the physical pressing effect * * to reduce the water content of extruded materials.

4. Wear and corrosion resistance

The key parts of the screw press are sprayed with wear-resistant layer, and the surface of the spiral auger blade is welded with alloy cutter head to increase the wear-resistance; The core components are made of 304 stainless steel, which is acid, alkali and corrosion resistant, greatly extending the service life of the equipment.

5. No need to add reagents

The 00.3mm-1.0mm clearance screen and screw press can be selected according to the properties of the materials to be dehydrated. During the dehydration process, flocculants and other agents do not need to be added, so the cost does not need to be increased, and the secondary utilization of materials will not be affected due to the addition of chemical components.

The design scheme of screw press is reasonable; Reliable application; High rate of solid-liquid separation equipment; Low feed concentration, high feed concentration; Less outflow, high acquisition rate and low operation cost; Simple installation, small floor area, convenient operation and small maintenance

Scope of work: The materials enter the new type dehydrator from the feed inlet. According to the dividing circle diameter of the spiral guide roller, the width becomes smaller, and the guide roller blade groove becomes shallower. Therefore, the working pressure of materials in the fitness exercise gradually increases, so that the material liquid is separated from the mesh according to the stainless steel plate, the separated liquid is discharged from the outlet at the bottom of the generator set and inside the guide roller, and the extruded materials are discharged from the inlet.

The key points of screw extrusion dehydration are motor shaft, feed inlet, screw guide roller, dehydration system software, filtering screen strand, stainless steel filter screen, reducer motor, etc. The company has many years of working experience in the field of spiral extrusion separator equipment, serving large and medium-sized enterprises in China. It can customize production according to the needs of materials. Adhering to the principle of "quality **********, customer first", we welcome customers to discuss and consult, and clearly put forward valuable suggestions and mutual development trends.